AN3923| Application Note
Maxim/Dallas > App Notes > FIBER-OPTIC CIRCUITS
POWER-SUPPLY CIRCUITS
Keywords: DS1859, I2C, Temperature contolled resistors, Look up table based resistor
Sep 14, 2006
APPLICATION NOTE 3923
Connecting Multiple DS1859 Devices on the Same I2C Bus
Some applications require that multiple DS1859 devices be connected on the same I2C bus. This application note shows how to change the I2C slave address on one of the DS1859 devices when two are connected together on the same I2C bus. The process described can then be extended and applied to any additional DS1859 devices added to that bus. The note also discusses how to access the device's auxiliary slave address.
Introduction
The DS1859 dual, temperature-controlled resistors does not allow the user to change the I2C slave address by using external pins. Instead, the device provides a programmable I2C slave address for the main memory. In an application it may be necessary to connect multiple DS1859 devices on the same I2C bus. Since all DS1859 devices have the same factory-default I2C slave address, it is therefore necessary to change the I2C slave address on one of more of these devices while they are still connected to the I2C bus. This application note explains how to change the I2C slave address on one of the DS1859 devices when two are connected together on the same I2C bus. The same principle can then be extended to multiple devices. The article assumes that the user can switch the WPEN pin on the DS1859 to a logic-high or logic-low as required. The DS1859 is also unique because it has two slave addresses for each device: one address for accessing the main memory which is programmable, and one fixed address (A0h) for access
ing the Auxiliary memory. Access to the Auxiliary memory is discussed at the end of the application note.
Connecting Two DS1859 Devices on the Same I2C Bus
To connect two DS1859s to the same I2C bus, one must change the device address on one device and keep the other device at the default address, A2h. This can be done by using the following procedure. 1. Drive the WPEN pin of one DS1859 (Device 1) to the signal ground. 2. Drive the WPEN of the other DS1859 (Device 2) high. 3. Set the MPEN bit of Device 2 high (Slave address A2h, Table 01h, Register 89h, bit 2). This action will program the MPEN bits of both the devices, but only Device 2 will be write protected because the WPEN pin of Device 1 is grounded. Any writes using slave address A2h after this step will only affect Device 1. 4. Change the slave address on Device 1 to any value desired (00h FEh, except A2h). For programming, use slave address A2h, Table 01h, Byte 8Ch. 5. Set the ADFIX bit of Device 1 high. (Slave address A2h, Table 01h, Register 89h, bit 4). 6. The slave address of Device 1 will now be configured to use the address specified in step 5. 7. The WPEN pins can then be driven to the desire
d logic levels, after which the MPEN bit can be changed back to its default value (0b).
Adding Additional DS1859 Devices to the System
The same procedure should be followed to connect multiple DS1859 devices on the same I2C bus. In each case
AN3923 Application Note maxim Download PDF
Add this permalink to your bookmarks for future download of AN3923 ApplicationNote
Permalink: http://application.emcelettronica.com/maxim/AN3923
