AN945| Application Note
Maxim/Dallas > App Notes > AUTOMOTIVE
POWER-SUPPLY CIRCUITS
Keywords: Step-Up Controller Forms Negative Step-Down Regulator
Jan 31, 2002
APPLICATION NOTE 945
Step-Up Controller Forms Negative Step-Down Regulator
Positive step-down switching regulators are common, but the complementary negative step-down function (converting a negative voltage to a smaller negative voltage) is rare by comparison. Figure 1 shows a negative step-down switching regulator that delivers 1A at -7.5V from -15V, with efficiency better than 90%. The IC is a step-up switching controller referenced to the negative rail.
Figure 1. This negative step-down circuit regulates -15V down to -7.5V. When the power switch (Q3) turns on, the current in L1 increases as long as VOUT is less negative than VIN. When this inductor current reaches the limit set by R6, Q3 turns off. Q3's drain flies high and is clamped to the positive supply rail (ground) by the catch diode (D2). Inductor current then decreases until Q3 turns on again. The output capacitor (C3) integrates inductor current to produce the output voltage. Output voltage is referenced to the positive supply rail, and Q4 reflects the error signal from the positive rail to the negative rail. When the error signal falls below the feedback threshold, the power switch turns on and initiates another switching cycle. D1, Q1, Q2, and R1-R4 form a startup circuit that holds IC1 in shutdown until VIN reaches approximately -11V. This action ensures that Q4 has sufficient voltage compliance to regulate the feedback loop. The minimum input voltage necessary to maintain a regulated output vol
tage is VOUT +(-VFB), where VFB is the feedback threshold voltage (1.5V in this case). Efficiency varies with load current as shown in Figure 2.
AN945 Application Note maxim Download PDF
Add this permalink to your bookmarks for future download of AN945 ApplicationNote
Permalink: http://application.emcelettronica.com/maxim/AN945
